Solar streetlight controller(one way output)

Fitting for the solar lighting system is automatically controlled below 80W (12V) or below 160W (24V) for both lighting and sola

Fitting for the solar lighting system is automatically controlled below 80W (12V) or below 160W (24V) for both lighting and solar panel.

I Function:

1. Preventing battery from over charging, over discharging and Reverse-Current during nights.

2. Controller will start up the lighting system in the evening automatically according to the intensity of the light

3. Controller will shut down the lighting system according to the time setting or shut down the lighting system automatically when it is dawn

II Connection (See the drawing below): 

Opening the top cover of the controller, connect the wire and terminal of the controller according to the drawing on the top cover of Controller.

1. Connect the +, - Poles of the battery to the relevant terminal of the controller (the third one and the fourth one from the left) firmly and correctly.

2. Connect the +, - Poles of the solar panel to the relevant terminal of the controller (the first one and the second one) firmly and correctly.

3. Connect the +, - Poles of the load to the relevant terminal of the controller (the fifth one and the sixth one from the left) firmly and correctly.

III Indicator LED                      

1. One piece of Charge Indicator LED (mark: Charge). When it is bright, the battery is charged strongly, flickeringly means floating charge, no light means stop charging.

2. One piece of Load Indicator LED (mark: Load). When it is bright, there is output and load can work; if LED go out, means there isnt output and the load cannot work.

Attention Items:

1. Before connection, please check and confirm the rated voltage of the solar panels, batteries and the loads carefully. These must be same rated voltage, all 12V or all 24V.

2. The rated current of the solar panels and the load must be less than the rated current of the controller.

The Parameter Sheet:

Rated Voltage	12V or 24V	Voltage of stop power supply	*10.8V or 21.6V
Rated charging current	5A	Voltage of resume power supply	*11.8V or 23.6V
Rated load current	5A	Voltage of stop charge	*14V o r28V
Working temperature	-20 ~  +40	Temperature Coefficient of Voltage stop charge	-3mV//cell
Size (Length*Width*Height)	75×39×115mm	Net Weight	130g

IV Enactment of the closing method for lighting

Long press the Set key, latter the green LED will be flickering, Start from 0,one flash is equal to 1 hour. As soon as fitting for the time, then loosening grip, the enactment finished. This is the method of time controlling for the lamp. If the time is more than 10 hours, the green light will flash fast, then loosening grip, the enactment finished, here the method is automatic light controlling for the lamp.

When the night is coming, the light will be on after 15mins.

V See about the method of closing:

Press the Set key 1 second, then loosen grip.

Time Controlling Pattern: When the green LED flash 1 time, it is 1 hours (2 Times/Second).

Light Controlling Pattern: It fast flash 4 Second10 Times/Second.

Solar streetlight controller(one way output)